Hydronic snow melting

Hydronic snow melt system design, coordinated end to end

A hydronic system uses a boiler and a glycol loop, instead of electric cable, to keep a surface clear. It's a real option for Ontario driveways and commercial properties — here is how it works, where it fits, and how we coordinate it.

The parts of a hydronic system

Six components working together, from the heat source to the surface.

  1. Boiler

    Heats the glycol-water mix. Sized to the area you want to heat and the climate.

  2. Glycol loop

    A glycol-water mix resists freezing in the tubing when the system is off between runs.

  3. PEX tubing

    Runs through the surface build-up in a loop layout designed for your area.

  4. Manifold

    Splits and balances flow across the tubing loops so heat reaches the whole design area evenly.

  5. Pump

    Circulates the heated fluid through the loop while the system runs.

  6. Sensor and controller

    Detects snow and ice conditions and switches the boiler and pump on and off, the same role as in an electric system.

Where it goes

Tubing is laid in the surface build-up the same way electric heating elements are, with the layout set for your surface and area.

Mechanical room and gas supply

What a hydronic system needs indoors, beyond the surface itself.

  1. Space for the equipment

    The boiler, pump, manifold and controls need an indoor space with the right clearances and access for service — confirmed during your design, not assumed.

  2. Gas or other fuel supply

    Most boilers run on natural gas or propane. Whether your property’s supply suits a given boiler is checked as part of planning.

  3. Venting

    Boilers vent combustion byproducts to the outside. The mechanical contractor confirms what your equipment and space require.

  4. Coordinated timing

    Mechanical work, electrical connections for controls, and the surface build all need to happen in the right order — the part MeltGrid coordinates.

Not sure if your property has what a hydronic system needs?

Request a project estimate

Hydronic snow melting questions

Direct answers first. For anything specific to your property, ask us and we will look at it in your design.

How does a hydronic snow-melting system work?

A boiler heats a glycol-water mix, a pump circulates it through tubing laid in or beneath the surface, and a snow and ice sensor tells the controller when to run. The warmth from the fluid melts snow and ice on the surface above it.

Does a hydronic system need a gas line?

Most hydronic boilers run on natural gas or propane, though electric and other boiler types exist. Whether your property has the gas supply and mechanical room space a given boiler needs is confirmed as part of your design, with the mechanical contractor.

What is a mechanical room, and do I need one?

The boiler, pump, manifold and controls need an indoor space with the right clearances, venting and access for service. Most homes and commercial buildings already have a suitable spot — a mechanical room, basement or garage corner — but it is confirmed during your design, not assumed.

Can hydronic go under asphalt, concrete or pavers?

Yes. The tubing is laid in the surface build-up the same way electric cable is, with a layout and loop design set for your project. The paving, concrete or interlock contractor and the mechanical contractor work to the same plan.

What maintenance does a hydronic system need?

Periodic checks of the boiler, pump, glycol concentration and controls, generally handled by the mechanical contractor as part of routine HVAC-style maintenance. Your design specifies what your system needs and how often.

Considering hydronic for your property?

Tell us about the project. We'll tell you plainly whether hydronic, electric, or both make sense.

Request an estimate